Interior Moulding / Trim: Service and Repair

Glasses holder, entry handle























INTRODUCTION
- NOTE! Read through the whole installation instruction before starting the work.
- The illustrations display the procedure in order of operation. The order of operation is repeated in the text section






Glasses holder, entry handle

Note! Some steps in these installation instructions are presented with illustration only.





Use: Electrician's screwdriver










- This will not be reused.





- Make sure that the four retaining plates (1) sit on each side of the nut plates where the glasses holder will be fastened. If there is not enough room for the plate, it can be broken off and discarded.





- Torque tighten the screws to 8Nm (6 lbf.ft.)