Fault-Tracing Information

Fault-tracing

Initializing the position of the window
For automatic window operation to work, the Driver door module (DDM)/Passenger door module (PDM) must sense the window's end position and the resistance the window lift experiences when it moves the window. The control module contains a preProgramd value on the resistor. Therefore, it is often sufficient to manually raise the window to its end position, with the control in the vehicle, in order to initiate it. The window may need moving to its lower end position.
In some cases, it may be necessary to perform an automatic initiation. During automatic initiation, the control module updates both resistance and end position.

Warning! During automatic initiation, the window is pushed up to its end position with great force, and this causes a pinching risk.

Run an initialization by clicking the VCT2000 symbol.





Continue - Verification

-------------------------------------------------

Verification

Hint: After carrying out the repair, check that the fault has been remedied.

- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
Check that the automatic operation of the power window mechanisms works.

Is the power window control operating correctly?

Yes - FAULT FOUND

No - Information

-------------------------------------------------

Information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Initializing the position of the window

-------------------------------------------------

Information
If initiating the windows did not help, fault trace according to the fault causes in the DTC information. Remedy as necessary. Then return to this fault tracing to try to initiate the window again.

Was the fault found?

Yes - FAULT FOUND

No - Information

-------------------------------------------------