Part 3

- Take the loose cable terminal in the antenna cable B and carefully secure the receptacle housing to the cables for the media player.

- Press the catch securely into the receptacle housing.

- Connect the previously disconnected cable terminal on the cable from the media player's receptacle housing to IN on TMC unit C.

- Connect the remaining end to antenna cable B to OUT on TMC unit C.

- Take the foam tape from the kit and remove the protective tape from it.

- Wrap foam tape around the TMC unit.

- Clamp the cable excess around the TMC unit using a cable tie from the kit. Ensure that there is enough excess to connect the antenna cable to the media player and the cable to the GPS cradle.

- Place the cable excess and TMC unit C in the space under the location for the media player.

A and B

- Connect the disconnected connectors to the media player.

Note! Space is confined at the media player and there are many cables so take care to ensure that it is positioned so that no cables are trapped or are at risk of being chafed.

- Install the media player and tighten using the two screws.

A and B

- Now position the cable harnesses from the GPS cradle and the hazard warning flasher in-between the two air ducts, when pushed into position.
- Secure the two small green connectors from the thin cable harness from the GPS cradle using a piece of butyl tape in a suitable position to prevent rattling.
- Connect the connector to the hazard warning flasher. Check between the ribs in the outlets so that the cables do not obstruct the air ducts.
- Carefully press the outlets into place.