Troubleshooting

Troubleshooting ECM-P242000

Checking the status




- Ignition on
Check if the malfunction is permanent or intermittent by opening and closing the valve in the leakage diagnostics unit. Listen for a clicking sound when the valve opens/closes.
If the valve is not heard, this indicates a permanent malfunction. If the valve can be heard, this indicates that the malfunction is intermittent and not active right now.





Continue - Checking component and cables

-------------------------------------------------

Checking component and cables
Check the leakage diagnostics unit's connector for contact resistance and oxidation.
Check the valve's resistance between the leakage diagnostics unit's connector #3 and #4.
Check the cable between engine control module (ECM) #B48 (#C48) and the leakage diagnostics unit #2 for short-circuit to voltage.
Remedy as necessary.

Other information
- Fuel system, draining, B8444S, B6324S5 Draining The Fuel System
- Leak diagnostic pump, replacing, B8444S, B6324S5 Service and Repair
- Checking wiring and terminals Checking Wiring And Terminals













Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After repairing, it is necessary to check that the malfunction has been fixed.








- Ignition off
- Reconnect the connectors, components, etc.
- Ignition on
- Start activation of the valve in the leakage diagnostics unit.
Listen for a clicking sound when the valve opens/closes.





Is the function OK?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Troubleshooting information

VERIFIED - FAULT FOUND

-------------------------------------------------

Troubleshooting information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking component and cables

-------------------------------------------------