Checking Connectors And Components

Checking connectors and components

Checking the wiring
Check the cables between control module and other included components. Check for open circuit, loose connections, contact resistance, and oxidation.
Remedy as necessary.

Other information
- Location of components Locations
- Checking wiring and terminals Checking Wiring And Terminals
- Connecting breakout box Connecting The Breakout Box, Power Operated Tailgate Module (POT)
- Checking the supply voltage/ground terminal Checking Of Voltage/Ground Connection, Power-Operated Tailgate Module (POT)

Was a fault detected?

Yes - Verification

No - Information

-------------------------------------------------

Checking connectors and components
If the tailgate cannot be opened with the hydraulics, it may be due to one of the included components not being connected correctly.
Check that all components are connected correctly.

Other information
- Location of components Locations

Was a fault detected?

Yes - Verification

No - Checking the wiring

-------------------------------------------------

Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
Check that the control responds as expected.

Do all the buttons operate normally?

Yes - FAULT FOUND

No - Information

-------------------------------------------------

Information

Attempt New Test - Checking connectors and components

-------------------------------------------------