Fault-Tracing Information

Fault-tracing information

Checking the ground terminal
Check the ground cable between Central electronic module (CEM) #C1:54 (#54), and the ground connection in the body for open circuit, loose connection, contact resistance and oxidation. With the ignition on, the drop in voltage between the ground connection for the control module and the ground terminal must not be greater than 0.5 V.
Remedy as necessary.

Other information
- Connecting the breakout box For Connection Of Breakout Box To Central Electronic Module (CEM)
- Signal specification Signal Description Central Electronic Module (CEM)
- Checking wiring and terminals Checking Wiring And Terminals

Continue - Verification

-------------------------------------------------

Verification








- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
Does the combined instrument panel work as it should?

Was a fault detected?

Yes - Information

No - FAULT FOUND

-------------------------------------------------

Information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

FAULT-TRACING FAILED - No Fault Found

Attempt New Test - Checking the ground terminal

-------------------------------------------------