Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information TCM-U030000

Condition
The control modules communicate with each other in a network via standardized serial communication - CAN (controller area network). The Central electronic module (CEM) regularly transmits messages on the CAN network. These messages contain information about which signal configuration ID applies to the vehicle. The control modules on the CAN network have the same signal configuration ID so that they can communicate with each other.
The control module compares its configuration ID with the signal configuration transmitted on the control area network (CAN) by the central electronic module (CEM).
The diagnostic trouble code (DTC) is stored if the control module detects that:
- The control module's configuration ID differ from the ID that the Central electronic module (CEM) transmits.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Starting the control module's CAN communication.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.

Hint: Emergency mode in the event of a fault Emergency Mode In Case Of Malfunction





Substitute value
- Control module shuts itself off ("bus-off").

Note! When the diagnostic trouble code (DTC) is stored, the control module responds to the diagnostic commands.

Possible source
- Incorrect configuration ID (the control module is not intended for this vehicle, for example it is a used control module with different software/hardware).
- Faulty software in transmission control module (TCM).

Fault symptom[s]
- Warning lights and chimes/Malfunction Indicator Light ("Check engine" light) indication/no indication