Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information TCM-P096500

Condition
Lock-up solenoid SLU controls the transmission lock-up function. Solenoid SLU works when it receives voltage from the transmission control module (TCM). The solenoid is activated during various driving conditions based on speed, throttle position and set driving program.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- The measured current in the solenoid circuit is incorrect.
Solenoid SLU can then not regulate system pressure.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Shifting when the lock-up function is activated.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- Auxiliary program Emergency mode 1 in the transmission control module (TCM) has started.

Hint: Emergency mode in the event of a fault Emergency Mode In Case Of Malfunction

Possible source
- Contact resistance in the terminals.
- Open-circuit in the cable for the control signal or signal ground.
- Lock-up solenoid SLU is stuck.
- Lock-up solenoid SLU not working.

Fault symptom[s]
- General warning lamp lit
- Malfunction indicator light (MIL), on
- Rough gear shift
- No gear shift
- Abnormal slipping gearshifts