Fault-Tracing Information

Fault-tracing

Calibration
The diagnostic trouble code indicates that calibration data does not match for the internal sensors in the stability sensor (BSC).
Calibrate Brake control module (BCM) according to information under Diagnostics/vehicle communication.
Remedy as necessary.





Continue - Reading off the status of the diagnostic trouble code (DTC)

-------------------------------------------------

Fault-tracing information

Attempt New Test - Calibration

-------------------------------------------------

Reading off the status of the diagnostic trouble code (DTC)
- Ignition on.
- Wait 1 minute.
- Read off diagnostic trouble codes (DTCs).
If the status of the diagnostic trouble code (DTC) has changed from permanent to intermittent the fault is no longer active.
If the diagnostic trouble code (DTC) status is permanent replace the Body sensor cluster stability sensor (BSC).

Other information:
- Accelerometer and yaw angle sensor Service and Repair









Is the status of the diagnostic trouble code (DTC) intermittent?

Yes - FAULT FOUND

No - Verification

-------------------------------------------------

Verification

Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off.
- Reconnect the connectors, reinstall components etc.
- Test drive the vehicle following:
- Ignition on.
Read off the status of the diagnostic trouble code (DTC).





Is the status of the diagnostic trouble code (DTC) intermittent?

Yes - FAULT FOUND

No - Fault-tracing information

-------------------------------------------------