Fault-Tracing Information

Fault-tracing

Fault-tracing




The control module has registered that invalid or incorrect data has been obtained from the vehicle configuration file.
The parameter could be incorrect because the parking assistance camera (PAC) module was replaced in an improper manner.
If the parking assistance camera module (PAC) is removed from one car and installed in another, vehicle configuration may no longer be correct.
If this is the case, remedy by replacing the parking assistance camera (PAC) module in a proper manner.

Other information:
- Location of components Component Location, Parking Assistance Camera Module (PAC)
- Parking Aid Camera Module Parking Aid Camera Module

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the relevant diagnostic trouble code (DTC) has switched status from permanent to intermittent fault.





Has the status of the diagnostic trouble code (DTC) changed?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

Attempt New Test - Fault-tracing

-------------------------------------------------





Information

Fault-tracing information
If the fault is intermittent, do not verify fault-tracing if the fault does not recur.
It is possible to view the information again, or leave fault-tracing for this diagnostic trouble code (DTC).

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Fault-tracing

-------------------------------------------------