Fault-Tracing Information

Fault-tracing

Checking the component
Check switch key-i in Start control module (SCU) by activating the tool.
The switch may not be activated when the remote key is not inserted in the ignition.
Insert the remote key in the ignition.
Status for switch key-i shall change.









Is the function OK?

Yes - Fault-tracing information

No - Replacing the Start Control Unit (SCU)

-------------------------------------------------

Fault-tracing information
The control module has previously registered a fault but the fault is no longer active.
Intermittent faults may be due to interference at start up of the control module or may be a different type of fault which occurs on different occasions. The fault is evaluated depending on how it occurs.
If the fault recurs, replace the control module. Remedy as necessary.
In the event of a permanent problem, replace Start control module (SCU).





Continue - No Fault Found

-------------------------------------------------

Replacing the Start Control Unit (SCU)
The control module has registered an internal fault.
Replace Start Control Unit (SCU).

Other information
- Ignition lock Service and Repair





Select "Continue" when you are ready.

Continue - REPAIRED

-------------------------------------------------