Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information CEM-B102496

Condition
Central electronic module (CEM) checks status of Start control module (SCU).
The diagnostic trouble code (DTC) is stored if the control module detects that:
- Start control module (SCU) reports an internal error.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Communication with Start control module (SCU).

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- None.

Possible source
- Internal fault in the control module.

Fault symptom[s]
- Starter motor does not operate
- Message in information display