Fault-Tracing Information

Fault-tracing

Checking the wiring and terminals




- Ignition off, wait for 15 seconds.
Check the charging function of the generator (GEN).
Check the battery voltage.
Remedy as necessary.

Other information
- Signal specification Pinout Values and Diagnostic Parameters
- For further information, see the wiring diagram.
- Fault-tracing and testing the battery Fault-Tracing and Testing the Battery
- Checking the power supply and ground terminal Checking Supply Voltage/Ground Terminal . Parking Aid Camera Module (PAC), Late Version
- Parking Aid Camera Module Parking Aid Camera Module
- Checking wiring and terminals Checking Wiring and Terminals

Continue - Information

-------------------------------------------------

Information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - FAULT FOUND

------------------------

Attempt New Test - Checking the wiring and terminals

-------------------------------------------------