Fault-Tracing
Fault-tracing
Replacing a component
Power Operated Tailgate Module (POT) has registered a failure on the hydraulic pump's relay. If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults may be due to interference upon start-up or may be another type of fault that can recur at different times. The fault is evaluated depending on how it occurs. If the problem returns, replace Power Operated Tailgate Module (POT).
Replace the Power Operated Tailgate Module (POT) in case of a permanent problem.
Other information
- Location of components Locations
Has Power Operated Tailgate Module (POT) been replaced?
Yes - Initiation of tailgate's position
No - Verification
-------------------------------------------------
Verification
Verification
Hint: After carrying out the repair check that the fault has been remedied.
- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
- Check the function by opening and closing the tailgate using the different button combinations.
- Read off the diagnostic trouble codes (DTCs) by clicking on the VCT2000 symbol.
- Check that the diagnostic trouble code has disappeared or changed status to intermittent. Then the problem has been solved.
Has the fault been remedied?
Yes - FAULT FOUND
No - Attempt New Test
------------------------
Attempt New Test - Information
-------------------------------------------------
Information
Attempt New Test - Replacing a component
-------------------------------------------------
Initiation of tailgate's position
Initiation of tailgate's position, Power Operated Tailgate Module (POT)
Initiation of tailgate's position
After changing Power Operated Tailgate Module (POT) the tailgate's position must be initiated in the software.
Carry out as follows:
- Load new software into the control module.
- Click the VCT2000 symbol and follow the instructions there.
DONE
------------------------
DONE - Verification
-------------------------------------------------