Level Sensor Fuel Tank, AW55-50/51SN, AW50/51 AWD, M66 AWD, M66

Level sensor fuel tank

Special tools:
999 7093 Wrench 999 7093 Wrench

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Remove the fuel tank. See: Fuel tank Removal and Replacement Fuel tank Removal and Replacement.

Removal

Removing the level sensor





Remove:
- the large plastic nut. Use tool: 999 7093 Wrench 999 7093 Wrench
- the level sensor.

Caution! Ensure that the lever on the level sensor is not damaged when removing the pump.

Transferring components

Transferring suction line





Note! Applies to vehicles equipped with auxiliary heater.

Remove the plug for the suction line from the underside of the level sensor, use a 9 mm socket.
Transfer the suction line to the new fuel pump.

Installation

Note! For tightening torques, see: Tightening torque Tightening Torque.

Installing the level sensor




Install the level sensor.

Caution! Ensure that the lever on the level sensor is not damaged when removing the pump.

Install the large plastic nut. Use tool: 999 7093 Wrench 999 7093 Wrench. Tighten according to Tightening torque Tightening Torque.

Note! Ensure that the level sensor marking is opposite the marking on the tank.

Finishing

Install the fuel tank. See: Fuel tank Removal and Replacement Fuel tank Removal and Replacement.