Integrated Booster Cushion Outer

Integrated booster cushion outer

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Removing booster cushions




Fold up the booster cushion.

Remove:
- the 2 M6 screws at the rear edge
- the 2 M6 screws at the front edge.




Detach the apron molding from the booster cushion. It is secured with 4 clips on the underneath of the booster cushion.
Remove the booster cushion from the vehicle.

Installation

Note! For tightening torques,.

Installing booster cushions
Secure the apron molding on the underneath of the booster cushion using 4 clips.
Press into place.

Install:
- the 2 M6 screws at the rear edge
- the 2 M6 screws at the front edge.

Finishing

Function test
Check the function of the booster cushion.