Fault-Tracing Information

Fault-tracing

Checking component and connections




- Ignition on
- Activate readout of electronic throttle unit's position.
- Check that read-off throttle position shows reasonable values at different deployments.
- Ignition off
Check engine control module ECM) and the electronic throttle unit's connector for contact resistance and oxidation.
Check if the electronic throttle unit is blocked by an object and press on the throttle disc to see if it binds.
Clean the electronic throttle unit if needed.

Other information
- Connecting the breakout box Connecting The Breakout Box, Engine Control Module (ECM)
- Signal specification Signal Specification, Engine Control Module (ECM)
- Throttle body Removal and Replacement
- Throttle body, cleaning Procedures
- Checking wiring and terminals Checking Wiring And Terminals













Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on
Activate readout of electronic throttle unit's position.
Check that read-off throttle position shows reasonable values at different deployments.





Are these values within their permitted ranges?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFIED - FAULT FOUND

VERIFICATION FAILED - Fault-tracing information

-------------------------------------------------

Fault-tracing information

Attempt New Test - Checking component and connections

-------------------------------------------------