Engine Control Module (ECM), Replacing

Engine control module (ECM), replacing

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Removal

Preparatory work




Ignition off.
Disconnect the battery negative cable. See: Battery, disconnecting Battery Disconnecting.

Removing the Engine Control Module (ECM)




Remove the cover by lifting it straight up.





Remove:
- the connectors, x2
- the bolts, x4
- the Engine Control Module (ECM).

Installation

Installing the Engine Control Module (ECM)

Note! Ensure that the rubber seal is positioned correctly in its groove.

Install:
- the Engine Control Module (ECM)
- the bolts, x4
- the connectors, x2
- the cover
- the battery's negative cable in accordance with: Battery, disconnecting Battery Disconnecting.

Ordering software
Order the software in accordance with: 8691283.

Finishing
Check that no diagnostic trouble codes (DTC) have been stored in the control module during the repair.
Test drive the vehicle and check the function of the engine.