CD Changer: Service and Repair

CD changer






















INTRODUCTION
- NOTE! Read through the whole installation instruction before starting the work.
- The illustrations display the procedure in order of operation. The order of operation is repeated in the text section.






CD changer




- Move the left-hand front seat to its rear position.
- Turn the ignition key to position 0.




- Remove the tunnel console's left-hand side panel by carefully pulling it away starting at the rear edge. The panel is secured with six clips on the inside.




- Fold aside the floor mat on the left side of the center console.




- Unplug the two connectors on the left side at the lever carrier.
- Disconnect the female connector for the fibre optic cables from the lever carrier bracket.





Remove the panel around the display and the media player:
- Press in the catch at one of the panel's upper corners. Use a small screwdriver. Carefully pry off the radio panel on the same side. Use a plastic weatherstrip tool.
- Carry out the same procedure on the other side. Then fold the radio panel backward in the vehicle.
- Pull up the radio panel until it detaches.

Hint: If there is difficulty removing the panel, press the panel back into place on both sides and start the removal procedure again. Start from the opposite side to before.




- Remove the gear lever panel by carefully prizing it away starting at the rear edge and then continuing forward. It is fitted with six catches underneath.





Illustrations A and B
- Remove the gear lever panel from the boot. First press in the four catches around the panel. Then pull the panel up. On certain car models there is a keypad at the front edge of the panel. If this is the case, remove the connector on the right-hand side in the center console to be able to remove the panel.









- Fold up the cover for the storage compartment in the rear section of the tunnel console.




- Remove the covers and screws at the rear edge of the upper panel section of the center console. First remove the screws on the rear of the panel and then remove the remaining screws on the top, ten in total.




- Remove the edge clip with cable from the lower section of the center console.




- Remove the upper section of the panel by moving it backward at the front edge and then lifting it out from the front edge of the storage compartment.




- Remove the two screws from the media player.




- Pull out the media player completely. Disconnect the connectors on the reverse side.
- Place the media player to one side, it will not be used again.




- Take the new CD changer from the kit and plug the connectors into the rear.
- Insert the CD changer into its location in the dashboard while making sure that the guide pins at the sides engage in the corresponding rails in the dashboard.

Note! Ensure that the wiring is not trapped when reinstalling the CD changer.

- Guide the CD changer in the guide pins on the front and tighten it using the existing screws.
- Reinstall the removed components according to the following steps.
















































- Download the software for the accessory's function.