Part 2

Navigation system, portable, Installation kit TMC (Continued)

Note! Ensure the stud bolts fit in their holes before securing the grille.

- Insert the cable with ferrite through the hole in the loudspeaker bracket. The foam ferrite must end up in the middle of the enlarged hole.
- Carefully secure the loudspeaker grille with the GPS holder in the loudspeaker bracket.




- Place the TMC unit with all the cable excess in the space under the media player.




- Reinstall the media player. Ensure that no cables are trapped.
















































- Ensure that the cable harness from the holder does not get trapped by the air vents.
- Pull out the cable with contact to the hazard warning light.
























- Turn the ignition key to position II.
- Reconnect the battery negative lead.

Applies to cars where Navigation system portable and Navigation system, portable, Installation kit TMC kit are all installed.
Applies to cars with loudspeaker grilles.
First carry out steps 67-120 of the Navigation system portable installation instructions.

Note! At step 93, drill out the hole to - 30 mm (1 3/16") to make room for the foamed ferrite.

Then carry out steps 17-61 of the Navigation system, portable, Installation kit TMC installation instructions.

Applies to cars without loudspeaker grilles

Applies to cars with portable Navigation system installed




- Place the front seat in its rearmost position.
- Turn the ignition key to position 0.
- Disconnect the battery negative lead.

Note! Wait at least three minutes before unplugging the connectors or removing other electrical equipment.












- Prize away the holder for the switch at the lower edge.
- Then prize at the upper edge while coaxing and pulling it out.












- Locate the holes. Pull the panel with air vents straight out.




- Use special tool 9512943.




- Remove the bolts of the panel underneath the glovebox and remove it.




- Remove the two screws.

Illustrations A, B and C




- Remove the six screws.
- Pull out the glove box slightly.
- Disconnect the connector at the rear edge.
- Remove the connectors on top and disconnect them.
- Remove the glovebox.













Gain access to disconnect the connector through the space where the glove box was.
- Disconnect the connector and remove the short cable splice from the GPS cradle. The catch is on the front edge of the connector.




- Follow the disconnected cable from the GPS cradle and disconnect the connector from the adjoining cable.
- Place the short cable splice to one side. A new one is in the kit.




- Remove the tunnel console's left side panel by carefully pulling it loose starting at the trailing edge. It is secured with six clips on the inside.




- Fold aside the floor mat on the left side of the center console.




- Unplug the two connectors on the left side at the lever carrier.
- Disconnect the female connector for the fibre optic cables from the lever carrier bracket.





Remove the panel around the display and the media player:
- Press in the catch at one of the panel's upper corners. Use a small screwdriver. Carefully pry off the radio panel on the same side. Use a plastic weatherstrip tool.
- Carry out the same procedure on the other side. Then fold the radio panel backward in the vehicle.
- Pull up the radio panel until it detaches.

Hint: If there is difficulty removing the panel, press the panel back into place on both sides and start the removal procedure again. Start from the opposite side to before.




- Remove the gear lever panel by carefully prizing it away starting at the rear edge and then continuing forward. It is fitted with six catches underneath.