Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information PBM-U210100

Condition
Park Brake Module (PBM) receives information about vehicle configuration in question from central electronic module (CEM).
The diagnostic trouble code (DTC) is stored if the control module detects that:
- Vehicle configuration from Central electronic module (CEM) is incorrect.
- The vehicle configuration from Central electronic module (CEM) is not the same as the one stored in the control module.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition switch position II.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.





Substitute value
- None.

Possible source
- Fault-trace in transmitting control module.
- Incorrect vehicle configuration (the control module is not intended for this vehicle, for example, it is a second-hand control module with different software/hardware).

Fault symptom[s]
- Message in information display
- Electrical parking brake; Reduced Functionality