Fault-Tracing

Fault-tracing

Information

Hint: The diagnostic trouble code indicates that a control module from another vehicle has been installed. If a Brake control module (BCM) has been installed from another vehicle with another configuration, the control module's configuration shall be reset. Erase the diagnostic trouble code (DTC).

Note! If other diagnostic trouble codes are stored in the control module these must be fault traced first.




- Ignition on.
- Erase the diagnostic trouble code (DTC).









Continue - Resetting and configuring the control module

-------------------------------------------------

Resetting and configuring the control module




- Ignition on.
- Reset the configuration on Brake control module (BCM).









Continue - Checking the diagnostic trouble codes (DTCs)

-------------------------------------------------

Checking the diagnostic trouble codes (DTCs)




- Ignition off.
- Wait 1 minute.
- Ignition on.
- Read off diagnostic trouble codes (DTCs).









Does the diagnostic trouble code (DTC) recur?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Information

-------------------------------------------------