Fault-Tracing

Fault-tracing

Replacing a component
The control module has registered an internal fault. Replace the control module.

Other information
- Driver door module (DDM) Driver Door Module (DDM)
- Passenger door module (PDM) Passenger Door Module (PDM)





Continue - Initializing the position of the window

-------------------------------------------------

Verification

Hint: After carrying out the repair, check that the fault has been remedied.

- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
Check that the automatic operation of the power window mechanisms works.

Is the power window control operating correctly?

Yes - Troubleshooting procedure complete

No - Information

-------------------------------------------------

Information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Replacing a component

-------------------------------------------------

Initializing the position of the window
After replacing the control module, the window position must be initialized.
Move the window to its upper limit position using manual control.
Run an initialization by clicking the VCT2000 symbol.





Continue - Verification

-------------------------------------------------