Fault-Tracing

Fault-tracing

Checking software
If the local configuration file is missing from the Phone module (PHM), the vehicle information, which is sent to the Volvo On Call Service Center, when a Volvo On Call service is activated, contains incorrect information.
Remedy this by downloading new software into the Phone module (PHM).





Continue - Verification

-------------------------------------------------

Verification




Verification




In order that the diagnostic trouble code (DTC) can be reread, the Phone module (PHM) must be restarted. Click the VCT2000 symbol to restart the control module and to erase and read out DTCs again.

Note! After erasing DTCs there is a delay to ensure that the diagnostics for the Phone module (PHM) have been carried out.

Check that the current DTC has disappeared or changed status from permanent to intermittent fault.





Are the diagnostic trouble code (DTCs) still stored?

Yes - Information

No - Troubleshooting complete for this DTC

-------------------------------------------------

Information




Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking software

-------------------------------------------------