Fault-Tracing

Fault-tracing

Replacing the component
The phone module (PHM) has registered an internal fault.
If the fault is intermittent, it has been registered previously but is no longer present. Intermittent faults may be due to interference upon start-up or may be another type of fault that can recur at different times. The fault is evaluated depending on how it occurs. If the fault recurs, replace the phone module (PHM).
In the event of a permanent fault, replace the phone module (PHM).
Remedy as necessary.

Other information
- Location of components Phone Module (PHM)
- Phone Module (PHM) Phone Module (PHM) Phone Module (PHM) Phone Module (PHM)





Continue - Verification

-------------------------------------------------

Verification




Verification
Erase diagnostic trouble codes (DTCs) in all control modules.
Read off the diagnostic trouble codes (DTCs) by clicking on the VCT2000 symbol.





Are the diagnostic trouble code (DTCs) still stored?

Yes - Fault-tracing information

No - Exit Fault-tracing

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

-------------------------------------------------