Fault-Tracing

Fault-tracing

Checking the wiring and terminals
The control module checks the communication with the Engine control module (ECM). A diagnostic trouble code for CAN communication can also be generated in the Central Electronic Module (CEM). In some instances, the diagnostic trouble code is generated in other affected control modules.
For further information on this diagnostic trouble code, see Diagnostic trouble code (DTC) information.

Other information:
- General information about fault-tracing in the CAN network Initial Inspection and Diagnostic Overview
- Checking wiring and terminals Checking Wiring and Terminals

Continue - Information

-------------------------------------------------

Information




Information

Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Exit Fault-tracing

------------------------

Attempt New Test - Checking the wiring and terminals

-------------------------------------------------