Fault-Tracing

Fault-tracing

Checking the status




- Ignition on.
- Read out the status during manual shifting (±).
- Depress the brake pedal. Move the gear selector to the position for manual shifting and check that the status changes.
- Move the gear selector to + and check that the gear selection is updated in the VIDA display and in the display on the driver information module (DIM).
- Move the gear selector to -. Check that the gear selection is updated.
If the gear selector position switches, the fault is intermittent. That is to say, it occurred earlier but is not active right now.
If gear selector position is not updated, replace the gear selector module (GSM).

Other information
- Top panel gear selector assembly, TF-80SC AWD, M66 AWD Top Panel Gear Selector Assembly, TF-80SC









Continue - Verification

-------------------------------------------------

Verification




Hint: After carrying out the repair, check that the fault has been remedied.




- Ignition off.
- Reinstall the connectors, components etc.
- Ignition on.
- Read out the status during manual shifting (±).
- Depress the brake pedal. Move the gear selector to the position for manual shifting and check that the status changes.
- Move the gear selector to + and check that the gear selection is updated in the VIDA display and in the display on the driver information module (DIM).
- Move the gear selector to -. Check that the gear selection is updated.









Is the function OK?

Yes - Troubleshooting complete for this DTC

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

-------------------------------------------------