Fault-Tracing

Fault-tracing

Checking the components and wiring








- Ignition off.
Check the cable between engine control module (ECM) #B16 (#C16) and battery for open circuit, contact resistance or oxidation.
Remedy as necessary.

Other information
- Connecting the breakout box, B6304T2 Connecting the Breakout Box
- Signal specification, B6304T2 Signal Description, Engine Control Module (ECM)
- Engine control module (ECM), B6304T2 Engine Control Module (ECM)
- Checking wiring and terminals Checking Wiring and Terminals

Continue - Verification

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the components and wiring

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Start the engine.
Read off the battery voltage.
Check the battery voltage, battery voltage shall be 13.5 V-14 V.





Is the function OK?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------