Fault-Tracing

Fault-tracing

Fault-tracing information
Check that the camera is installed correctly to Forward Sensing Module (FSM).
If the camera is connected correctly:
Isolate the defect by replacing existing components, one at time, for those that are known to work. When the problem has been isolated, replace the defective component.
Try by replacing components in the following order:
1. Camera cable harness.
2. Camera.
3. Forward Sensing Module (FSM).

Other information
- Camera collision warning Service and Repair
- Collision warning control module Service and Repair Collision warning control module, R.H.D Service and Repair Collision warning control module, L.H.D Service and Repair

Continue - Information

-------------------------------------------------

Information




Fault-tracing information
In case of this defect, troubleshooting is not followed by verification.
The information can be displayed again or the fault-tracing for this fault can be interrupted.

Do you want to view the information again?

Yes - Attempt New Test

No - Exit Fault-Tracing

-------------------------------------------------