Fault-Tracing

Fault-tracing

Checking the wiring








- Ignition off
- Disconnect the antenna connector.
Check the connector and antenna cable between the Remote Digital Audio Receiver (RDAR) and satellite antenna. Check for a short-circuit to supply voltage.
Remedy as necessary.

Other information
- Location of components Component Location, Remote Digital Audio Receiver (RDAR)
- Signal specification Signal Specification, Remote Digital Audio Receiver (RDAR)
- Checking wiring and terminals Checking Wiring and Terminals
- Satellite radio control module Satellite Radio Control Module

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the radio is working and that the reception is acceptable.

Is the radio playing through the loudspeakers?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the wiring

-------------------------------------------------