Fault-Tracing

Fault-tracing

Checking the wiring








- Ignition off
- Disconnect the antenna connector.
Check the terminal. Check for contact resistance. Check for loose connections. Check for oxidation.
Check the connector and antenna cable between the Remote Digital Audio Receiver (RDAR) and satellite antenna. Check for a short-circuit to ground.
Remedy as necessary.

Other information
- Location of components Component Location, Remote Digital Audio Receiver (RDAR)
- Signal specification Signal Specification, Remote Digital Audio Receiver (RDAR)
- Checking wiring and terminals Checking Wiring and Terminals
- Satellite radio control module Satellite Radio Control Module

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
- Ignition on.
Check that the radio is working and that the reception is acceptable.

Is the radio playing through the loudspeakers?

Yes - Troubleshooting procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit fault-tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the wiring

-------------------------------------------------