Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information CEM-B113C11

Condition
The central electronic module (CEM) supplies voltage to the lighting in the switch for flashing hazard lights.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- Signal too low from the output.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Activated flashing hazard lights.

Note! The control module can only detect the fault once the test has been started and the diagnostic trouble code (DTC) is stored when the conditions are met.

Substitute value
- The function switches off permanently after 100 operating cycles where the fault was detected. Erasing diagnostic trouble codes (DTCs) resets the result.

Possible source
- Short-circuit to ground in the power supply cable.

Fault symptom[s]
- Non-definable symptom