Fault-Tracing

Fault-tracing

Checking the ignition switch
- Change to another key belonging to the vehicle. Try to start the engine.
- If it works with another key new software must be ordered for the key that does not work.
- If it does not work with another key, the Start Control Unit (SCU) is defective and must be replaced.
- Remedy as necessary.

Other information:





Continue - Verification

-------------------------------------------------





Verification

Note! After carrying out the repair check that the fault has been remedied.








- Ignition off.
- Reinstall the connectors, components etc.
- Check that the vehicle can be started.

Can the vehicle be started?

Yes - Troubleshooting complete for this DTC

No - Information

-------------------------------------------------





Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-tracing

No - Attempt New Test

-------------------------------------------------