Fog Lamps

Fog lamps

























INTRODUCTION
- NOTE! Read through the whole installation instruction before starting the work.
- The front page gives the date of this edition and the edition it replaces
- The second page shows the tools needed for the installation and the contents of the installation kit
- The illustrations display the procedure in order of operation. The order of operation is repeated in the text section
- Cut out the text page in order to follow the illustrations and text at the same time.






Fog lamps

Installation








- Carefully pry off the panel starting at the right-hand end. It is secured with six mounting hooks. New panel in the kit.

Illustration A




- Detach the pre-routed connector for the fog lamp inside the removed panel.
- Connect the connector to the fog lamp.

Illustration B




- Position the fog lamp. Ensure that the two pins are inserted into the corresponding cut outs in the bumper cover.




- Install the screws from the kit and tighten the fog lamp properly.
- Repeat previous steps for the other side.

Installing the keypad




- Remove the keypad for the lighting by carefully prying it from the dashboard using a weatherstrip tool. It is secured with two catches on each side.

Note! Do not damage the dashboard.




- Unplug the connector from the keypad. Remove the connector. It will not be used again.
- Plug in the connector of the new keypad from the kit.
- Press the keypad into place in the dashboard.

Finishing work




- Set the height of the fog lamps using the adjustment screw.




- Install the new panel from the kit around the fog lamp in the bumper cover. Ensure that all mounting hooks engage.
- Repeat previous steps for the other side.




- Download the software for the accessory's function following the service information in VIDA.