Fault-Tracing

Fault-tracing

Fault-tracing information
Use the following information and general checks during fault-tracing.

Note! Check that the fuses are intact. For locations, see the instruction manual, cover for fuse box, fuse ratings or similar.

1. Check, if possible, relevant functions in the vehicle using buttons/controls/test drives to determine the status of the fault.

Note! If the vehicle does not show any of the given symptoms in the diagnostic trouble code information (DTC), this may mean that the fault is intermittent or that the control module is not detecting the fault at this moment.

2. Use the diagnostic trouble code's frozen values, status identifiers and counter to determine the operating conditions when the fault was detected, the fault's current status and any degree of intermittence of the fault.
3. Check and fault-trace according to the fault causes that are specified in the diagnostic trouble code (DTC) information.
4. Use VIDA Vehicle communication. Read off the parameters, activate components and functions, carry out quick tests and checking routines for the diagnostic trouble codes to identify the fault.
5. Check relevant components according to Component specifications.
6. Check relevant signals using wiring diagram, signal specification and breakout box.

Note! More information is available in Design and function.

Remedy as necessary.

Other information
- Description of frozen values, B8444S Description Of Frozen Values, ECM
- Description of status identifier Description Of Status Identifier
- Description of counter Description Of Counter
- Description of parameters , B8444S Description Of Parameters
- Description of activations, B8444S Description Of Activations
- Location of components, B8444S Locations
- Component specifications, B8444S Component Specifications, Engine Control Module (ECM)
- Connecting the breakout box, B8444S Connecting The Breakout Box, Engine Control Module (ECM)
- Signal specification, B8444S Signal Specification, Engine Control Module (ECM)
- Checking wiring and terminals Checking Wiring and Terminals













Continue - Verification

-------------------------------------------------

Information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Fault-tracing information

-------------------------------------------------

Verification

Hint: After carrying out the repair, check that the fault has been remedied.

- Read off the diagnostic status and the fault status for the diagnostic trouble code (DTC).
- Check that the diagnosis is Performed.

Hint: To enable performing diagnostic status, special conditions must be fulfilled. These conditions are described in diagnostic trouble code (DTC) information for each diagnostic trouble code (DTC).

If the function is correct, the fault status must be No fault found when the diagnostic is complete.





Is the function OK?

Yes - Troubleshooting complete for this DTC.

No - Information

-------------------------------------------------