Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information

Condition




The engine control module (ECM) regulates camshaft position (angle position) by regulating the changeover valve camshaft. The diagnostic trouble code is generated if the control module detects that the control signal for the changeover valve camshaft is too low.
The diagnostic trouble code can be diagnosed when the ignition is on.

Substitute value
- Camshaft regulation deactivated.

Possible source
- Contact resistance in the connectors.
- The signal cable is short-circuited to ground.
- The power cable is short-circuited to ground.
- Damaged camshaft reset valve

Fault symptom[s]
- Malfunction indicator lamp (MIL) lit.
- Uneven idle.
- Poor performance.
- The engine stops while running.