FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Design






Design

Antenna




The carphone has a separate antenna. This antenna contains a GPS antenna and a carphone antenna. The carphone antenna is directly connected to the phone module (PHM). The antenna is on the roof.
There are diagnostics for the carphone antenna.

Handset




The handset is directly connected to the phone module (PHM). The handset is located in the center console beneath the cover.
The phone module (PHM) determines if the call is to be connected via handsfree or handset from the click signal of the handset. When the handset is in the holder all calls are connected via handsfree. The handset is activated when it is removed from the holder. Note that voice calls do not go via the handset if it is lifted when an incoming call arrives or when an out going call is started using the ENTER button. The handset must be replaced and then lifted again for conversations via the handset. The reason for this is to avoid missing sound when the handset has been lifted accidentally. The click signal to the phone module (PHM) is controlled by a magnetic switch placed in the handset. The switch is closed by the magnet in the handset. When the handset is in the holder the click signal to the phone module (PHM) is 0 V, when the handset is used the signal is 5 V.
There are diagnostics for the handset.

SIM card holder




The holder for the customer's private SIM card is located up on the inside of the glove compartment on the left-hand side.
The SIM card holder is directly connected to the Phone module (PHM).
There are diagnostics for the SIM card holder.

Switches for Volvo On Call




The ON CALL and SOS switches are located on the ceiling lamp console. Switches are only available for the phone module (PHM) with Volvo On Call functionality.
The switches are directly connected to the phone module (PHM).
The switches also contain an emergency microphone.
Switch illumination receives is power supply and ground via the phone module (PHM).
There are diagnostics for the switches.