Tire Pressure Sensor: Service and Repair

Pressure sensor tire

Operation number: 38641-2

Note! Some variation in the illustrations may occur, but the essential information is always correct.

Removal

Note! Removal steps in this procedure may contain installation details.

Remove the wheel.





Caution! Do not use tools within the marked area.

Caution! Always start outside the marked area and continue in the direction from the valve.

Caution! Release the tire bead from the wheel rim diagonally opposite to the valve.

Remove the tire from the rim.





Note! Always use new valves when replacing tires.

Remove the following items:
- sensor from valve.
- valve.

Installation

Install the sensor on the valve. Tighten screw. Refer to: Tightening torque [1][2]Specifications.




Brush the valve (1) with soapy water and install the valve on the rim.





Caution! Do not use tools within the marked area.

Caution! Always start outside the marked area and continue in the direction from the valve.

Fit the tire and balance the wheel.

Install wheel. Refer to: Installing wheels Service and Repair

After replacing sensors, the control module does not need programming. The control module contacts the sensor itself after a few minutes driving. LF initiator can be used.