Gearshift Knob, Automatic

Gearshift knob, automatic
















INTRODUCTION
- NOTE! Read through the whole installation instruction before starting the work.
- The illustrations display the procedure in order of operation. The order of operation is repeated in the text section.






Gearshift knob, automatic




- Loosen the gaiter from the gear lever knob by turning the lock ring on the inside 1/4-turn, and pull down the gaiter.




- Pull loose the gear lever knob by forcefully pulling it straight upward.

Note! A lot of force is required to pull it loose.




- Place the new knob in the correct position on the gear lever.
- Drive down the knob in position.

Hint: Use, e.g., a plastic hammer and a spacer between the knob and hammer to avoid damaging the gear lever knob.




- Check that the gaiter's seams are straight. Then fix the lock ring by pulling it down and the gaiter straight up against the knob, and secure it by pressing it into place.
- Check that the gear lever knob is fastened securely by pulling on it. Also check that the lockout function works in all its positions.