Torque Bracket, Engine, Replacing

Torque bracket, engine, replacing

Removal and Installation

Removing the engine bracket

Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the essential information in the illustrations is always correct.





Remove:
- the engine cover by pulling it straight up
- the torque rod. See
- the bracket for the crankcase ventilation hose
- the lifting lug
- the torque bracket.

Installing the torque bracket





Remove:
- the torque bracket. Tighten the screw (A). Tighten to17Nm. Tighten the screws (C). Tighten to 50 Nm
- the lifting lug and the bracket for the crankcase ventilation hose. Tighten to 10Nm
- the torque rod. See Replacing The Torque Rod
Tighten the screws on the suspension turret. Tighten to 50 Nm. Tighten the screw in the torque bracket (B). Tighten to 80 Nm
- the engine cover.