Wheel Sensor Rear, Replacing

Wheel sensor rear, replacing

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Ignition off.
Remove the wheel.

Removal

Removing the wheel sensor





Note! Blow clean around the sensor using compressed air before removing.

Remove the M5 mounting screw for the sensor Pull out the connector.




Remove the wheel sensor from the connector.

Installation

Note! For tightening torques, see Specifications. [1][2]Specifications

Installing the wheel sensor

Install:
- the wheel sensor in the connector
- the connector
- the M5 screw. Tighten. See: Tightening torque [1][2]Specifications.

Finishing

Function test
Install the wheel. See: Wheels Service and Repair.
Function test
Read off any diagnostic trouble codes (DTCs) stored in the control module.
Erase.
Interrupt the diagnostic function by turning off the ignition.
Test drive the car. See: Test Drive Form (ABS), description Test Drive Form (ABS).
Check that no diagnostic trouble codes (DTCs) are stored.
Interrupt the diagnostic function by turning off the ignition.