Fault-Tracing

Fault-tracing

Information
There is no fault-tracing for this diagnostic fault code (DTC).
A diagnostic trouble code for CAN communication can also be generated in the Central Electronic Module (CEM). In some instances, the diagnostic trouble code is generated in other affected control modules. This diagnostic trouble code shall not be cleared until the trouble code in the central electronic module (CEM) and in other affected control modules has been remedied and cleared.
Therefore, first read the diagnostic trouble codes in the Central Electronic Module (CEM) and other affected control modules, perform fault tracing and remedy as necessary. If no diagnostic trouble codes (DTCs) are stored, fault-trace the controller area network (CAN) as follows.
For further information on this diagnostic trouble code, see Diagnostic trouble code (DTC) information.

Other information:
Remedy as necessary.





Continue - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

-------------------------------------------------