Diagnostic Trouble Code (DTC) Information

Diagnostic trouble code (DTC) information DEM-P063468

Condition

Note! This diagnostic trouble code (DTC) status is an event controlled diagnostic trouble code (DTC). An event controlled diagnostic trouble code (DTC) does not mean that there is a fault in the control module when it is active, but is designed as information.

The Differential Electronic Module (DEM) has a temperature sensor fitted on the control module's circuit board. The sensor provides the Differential Electronic Module (DEM) with information about the temperature in the control module. If the temperature exceeds a preset value all wheel drive is disabled. This is to protect the components from a too high load, which can result in internal mechanical faults.
The diagnostic trouble code (DTC) is stored if the control module detects that:
- The temperature is higher than 110 °C.
The control module's test for the diagnostic trouble code (DTC) starts in the event of:
- Ignition on.





Substitute value

- Four wheel drive is disengaged.

Possible source
- Temperature too high.

Fault symptom[s]
- All wheel drive doesn't work