Fault-Tracing

Fault-tracing

Function test
- Remove the key from the ignition switch.
The steering column lock must be locked. It must be impossible to turn the steering wheel.
- Insert the key in the ignition switch.
The steering column lock must be unlocked. It must be possible to turn the steering wheel.
Try to read out the steering wheel lock's status.
Click on the VCT2000 symbol.
- Remove the key from the ignition switch.
The status of the steering column lock must be changed to locked.
- Insert the key in the ignition switch.
The status of the steering column lock must be changed to unlocked.









Is the function OK?

Yes - Fault-tracing information

No - Replacing the control module

-------------------------------------------------

Replacing the control module
- Ignition off.
Replace the control module if the Steering Column Lock Module (SCL) does not work as it should.

Other information
- Steering lock Service and Repair

Continue - Verification

-------------------------------------------------

Fault-tracing information
If no fault is discovered, this indicates that the control module has previously registered a fault, but that the fault is no longer present. The fault is intermittent. No further fault-tracing is required.

Continue - DONE

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
Check the operation of the steering column lock by inserting the remote key in the ignition. The steering column lock must be unlocked. It must be possible to turn the steering wheel.

Can the steering wheel be turned?

Yes - Troubleshooting complete for this DTC

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Function test

-------------------------------------------------