Fault-Tracing

Fault-tracing

Checking the function
- Check the operation of the steering column lock by inserting the remote key in the ignition. The steering column lock must be unlocked. It must be possible to turn the steering wheel.
- Remove the key from the ignition switch. The steering column lock must be locked. It must be impossible to turn the steering wheel.
If the function is correct, this is an indication that the fault was present previously but is not active at the moment, i.e. an intermittent fault. Erase the diagnostic trouble code (DTC) and read out again. If the diagnostic trouble code (DTC) does not recur no further corrective action is required.
Remedy as necessary.

Other information
- Steering lock Service and Repair

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
Check the operation of the steering column lock by inserting the remote key in the ignition. The steering column lock must be unlocked. It must be possible to turn the steering wheel.

Can the steering wheel be turned?

Yes - Troubleshooting complete for this DTC

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Checking the function

-------------------------------------------------