Fault-Tracing

Fault-tracing

Programming control module
The diagnostic trouble code (DTC) is stored when the central electronic module (CEM) discovers that the steering column lock module (SCL) has not been programmed.
The fault may be caused by:
- There has been a fault during a previous programming
- The customer has replaced the control module himself
- The control module has been replaced at a workshop and programming has not been carried out
Load new software into the control module.

Other information
- Steering lock Service and Repair

Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
Check the operation of the steering column lock by inserting the remote key in the ignition. The steering column lock must be unlocked. It must be possible to turn the steering wheel.

Can the steering wheel be turned?

Yes - Troubleshooting complete for this DTC

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Programming control module

-------------------------------------------------