Fault-Tracing

Fault-tracing

Programming control module
The diagnostic trouble code is generated when Central Electronic Module (CEM) registers that Steering Column Lock Module (SCL) is not programmed correctly.

Note! The Steering Column Lock Module (SCL) cannot be programmed. The control module must be replaced and a new control module programmed.

Remedy as necessary.

Other information
- Steering lock Service and Repair





Continue - Verification

-------------------------------------------------

Verification




Verification

Hint: After carrying out the repair, check that the fault has been remedied.








- Ignition off
- Reinstall the connectors, components etc.
Check the operation of the steering column lock by inserting the remote key in the ignition. The steering column lock must be unlocked. It must be possible to turn the steering wheel.

Can the steering wheel be turned?

Yes - Troubleshooting complete for this DTC

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information




Information

Fault-tracing information
The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-Tracing

No - Attempt New Test

------------------------

Attempt New Test - Programming control module

-------------------------------------------------