Ride Height Sensor: Service and Repair

Position sensor suspension rear (Four-C), replacing

Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential information in the illustrations is always correct.

Preparatory work

Ignition off




Ignition off.
Raise the vehicle.

Removal

Removing the position sensor





Remove:
- the nut for the linkage
- the position sensor. Press in the catch hook and angle the bracket downwards
- the connector
- the bracket from the position sensor
- the 2 screws.

Installation

Installing the position sensor

Install:
- the position sensor on the bracket
- the 2 screws
- the connector
- the linkage
- the nut.
Align the bracket which the position sensor is on. Press into position.

Finishing

Calibrating the position sensor
The position sensor must be calibrated after replacement.
Calibrate the position sensor.