Seat Latch: Testing and Inspection

Collision protection unit from behind front seat check

Operation number: 85244-2

Note! Some variation in the illustrations may occur, but the essential information is always correct.

Removal




Only applies to vehicle with fixed backrest.

Remove the following items:
- Side panel Refer to: Side panel front seat, replacing Side Panel Front Seat, Replacing
- end-plate Refer to: End mounting, replacing End Mounting, Replacing.









Caution! The operation must be performed on both sides of the seat.

Caution! No visible space may be seen between the rivet and end-plate.




In case of visible space between the rivet and end-plate, the rear end collision module for front seat shall be replaced Refer to: Rear end collision module front seat .




Only applies to vehicle with foldable backrest.




Adjust the backrest angle until the unit is visible.





Caution! The operation must be performed on both sides of the seat.

Caution! No visible space may be seen between the rivet and end-plate.





Caution! In case of visible space between the rivet and end-plate, the rear end collision module for front seat shall be replaced Refer to: Rear end collision module front seat .

Installation

To install, reverse the removal procedure