Reading the User Information

Checking the cassette player

Reading the user information




- Ignition on.
If the audio unit is equipped with a cassette player: insert a cassette and select cassette player with the "SOURCE" knob.
Click on the VCT 2000 symbol to read the user information.





Is any user information stored?

Yes - Checking the cassette player and cassette

No - No Fault Found

-------------------------------------------------

Checking the cassette player and cassette




- Ignition on.

Hint: Check that the volume is not turned down. Check other sound sources, for example whether the radio is working.

Check that there is nothing in front of the opening to the cassette player.
Check that there is nothing in the cassette compartment.
Test with a new tape.
Do the necessary corrective action.

Additional information:
- AUM diagnostic functions AUM Diagnostic Functions






Continue - Verification

-------------------------------------------------

Verification




Verification

Verification

Hint: After the repair it is necessary to check that the error has been rectified.








- Ignition off.
- Connect connector, install components etc.
- Ignition on.
Check that the cassette player is working.
Read the user information again and check that the status has changed.





Does the cassette player work?

Yes - VERIFIED

No - VERIFICATION FAILED

------------------------

VERIFICATION FAILED - Trouble-shooting information

VERIFIED - Fault Found

-------------------------------------------------

Trouble-shooting information
Since the error has not been detected and rectified, the error may be caused by a defective main unit/audio control unit (AUM). Continue by checking the main unit/audio control unit or try again.

Try again?

Yes - Checking the cassette player and cassette

No -

-------------------------------------------------





Checking the head unit / audio module

Fault-tracing information
Before continuing with fault-tracing, the following must be checked:
- All tests for the relevant symptom must have been carried out
- No component, connector or wiring faults etc. should have been detected.

Have all tests been carried out and no faults detected?

Yes - Replacing the component

No - No Fault Found

------------------------

Replacing the component
Try a new head unit / audio module.

Caution! New head unit / audio control modules are supplied without software. The head unit / audio control module must be programmed after it has been replaced.

Other information:
- For information about programming and accessing or replacing the main unit and/or audio control module, see Radio/telephone, changing Service and Repair.

Was a fault detected?

Yes - Fault Found

No - No Fault Found

------------------------

No Fault Found - No Fault Found

FAULT FOUND - Fault Found

-------------------------------------------------